Google Search

Custom Search

Powered by...

Find us on Facebook

Friday 23 November 2018

Z-Wave roller blinds with Dooya motor, Vera controller and Fibaro shutter module - Part 2

In part one here I discussed purchasing a motorised roller blind kit for my kitchen patio window. I will be integrating the motor in to my Home Automation controller (Vera) by using a Z-Wave Fibaro roller shutter module.

As its an AC mains powered motor, I had to do some preparation work for the installation of the electric cables and for the wall switch.

Luckily I already had a nearby switch fuse spur, so I decided to take the feed from there.

I wanted to mount the manual wall switch on the wall and also needed to run power up to the top of the window reveal where the roller blind / motor will be.

I had to create a channel in the plaster and install a metal back box. I just took my time and used a stanley knife and a hammer and chisel, to try and keep the dust down, although it was still quite a messy job. I removed the plaster back down to the block work.

I measured out the location of the wall switch first and then drew on the wall where I was to cut and knock out the plaster.



I then proceeded to chase out the wall.



When it came to the back box for the wall switch, my original plan was to fit the Fibaro roller shutter module behind the wall switch, so I put in a deeper 35mm metal back box. 

However later I decided I might not have enough room behind the wall switch for all the cabling and connectors, 35mm was the max depth of back box I could fit in to the block work, so opted for an additional surface mount box in the window reveal instead to house the module and connectors. 





Here you can see the channel inside the window reveal heading up to the motors location. I drilled two holes through the corner of the wall deeper than 50mm to feed the electric cables through.


I fitted the electric cable and clipped it to the block work and then filled in the channel and installed the metal back box for the switch. 



I using a Scolmore Minigrid 3 position retractive wall switch and some Wago connectors for the wiring.



Below you can see the deeper 47mm surface mount box, I now plan to put the roller shutter module into with the wires and connectors. 

Also you can see the electric cables now, the mains feed has been fed up from under the floor, up the channel on the wall, through the metal back box and up to the surface mount box, to feed the power to the module and motor. The second cable only goes from the surface mount box to the metal back box for the wall switch connections. 


I'm not sure about the final position of the surface mount box, it may need to be moved higher up but I wanted to leave enough room to fit the roller blind. 


Final fine filler and sanding to make the walls good again.



And all finished and painted and looking good again.



The actual roller blind kit arrived yesterday. However no mounting brackets could not be found. I contacted the seller and he said the brackets are sent separately in another box, so I am still waiting for those to turn up.

I think I got lucky with FedEx as I didn't have to pay any import tax at the door and just signed for it. So unless they try and invoice me later for import tax, I've not paid any.



And here is the wiring diagram I will be working with.



Well that's it for part two. In part three I will have more photos of the roller blind kit and maybe photos of it installed and a video of it working.

No comments: